An Overview of the VLA

The Karl G. Jansky Very Large Array (VLA) is a 27-element interferometric array, arranged along the arms of an upside-down "Y", which will produce images of the radio sky at a wide range of frequencies and resolutions. It is located at an elevation of 2100 meters on the Plains of San Agustin in southwestern New Mexico, and is managed from the Pete V. Domenici Science Operations Center (SOC) in Socorro, New Mexico.

The basic data produced by the VLA are the visibilities, or measures of the spatial coherence function, formed by correlation of signals from the array's elements.  The most common mode of operation will use these data, suitably calibrated, to form images of the radio sky as a function of sky position and frequency.   Another mode of observing (commonly called phased array) allows operation of the array as a single element through coherent summation of the individual antenna signals. This mode is most commonly used for Very Long Baseline Interferometry (VLBI) observing and for observations of rapidly varying objects, such as pulsars.

The VLA can vary its resolution over a range exceeding a factor of ∼ 50 through movement of its component antennas. There are four basic antenna arrangements, called configurations, whose scales vary by the ratios 1 : 3.28 : 10.8 : 35.5 from smallest to largest. These configurations are denoted D, C, B, and A, respectively. In addition, there are 3 "hybrid" configurations labelled DnC, CnB, and BnA, in which the North arm antennas are deployed in the next larger configuration than the SE and SW arm antennas. These hybrid configurations are especially well suited for observations of sources south of δ = −15° or north of δ = +75°, for which the foreshortening of the longer North arm results in a more circular point spread function.  For details about antenna positions in the various configurations we refer to the relevant postscript file.

The VLA completes one cycle through all four configurations in an approximately 16 month period.    The VLA configuration schedule for 2014/2015 is presented in Table 3, but prospective users should consult the web page http://science.nrao.edu/facilities/evla/proposing/configpropdeadlines.shtml or recent NRAO and AAS newsletters for up-to-date schedules and associated proposal deadlines.  Refer to the Guide to Proposing for the VLA for information on how to submit an observing proposal.

Observing projects on the VLA will vary in duration from as short as 1/2 hour to as long as several weeks.  Most observing runs have durations of a few to 24 hours, with only one, or perhaps a few, target sources.  However, since the VLA is a two-dimensional array, images can be made with data durations of less than one minute.  This mode, commonly called snapshot mode, is well suited to surveys of relatively strong, isolated objects.  See Snapshots for details.

All VLA antennas are outfitted with eight receivers providing continuous frequency coverage from 1 to 50 GHz. These receivers cover the frequency ranges of 1-2 GHz, 2-4 GHz, 4-8 GHz, 8-12 GHz, 12-18 GHz, 18-26.5 GHz, 26.5-40 GHz, and 40-50 GHz and the bands are commonly referred to as L, S, C, X, Ku, K, Ka, and Q bands, respectively.  In addition, all antennas of the VLA now have even lower frequency receivers, covering 230-470 MHz (P-band).  And a small number are being outfitted with even lower frequency receivers, covering 54-86 MHz (4-band).

The VLA correlator is both powerful and flexible.  Details of the correlator configurations being offered for VLA science in 2015 are described in the WIDAR Section of this document.   It is important to realize that the VLA correlator is fundamentally a spectral line correlator and that even 'continuum' observations are done in a wide-band mode with many channels.